How can you pair the TaoTronics Audio Transmitter with a mobile device via Bluetooth? What do the LED colors mean? How to perform a reset?
 |
Manufacturer: TaoTronics
|
CAUTION: Electrical Device. Read the safety instructions!
Step 1
Ensure that the TaoTronics TT-BA06 audio transmitter battery is fully charged and connected via the 3.5 mm audio jack to the audio system. You will have to select the “AUX” oder “Line-Out” jack as a source. Do not separate the two devices for more than 3 feet while pairing.
Step 2
Press and hold the power button (middle) on the unit for approx 6-7 seconds. First the blue and green LEDs flash, then the red and blue LEDs will flash alternatively. The transmitter is now ready for pairing and can be connected with other Bluetooth enabled devices. If no Bluetooth connection will be established within 2 minutes, the transmitter turns off automatically.
Step 3
Turn on the Bluetooth mode on your mobile device. It will automatically search for other Bluetooth enabled devices nearby. Choose the “TaoTronics TT-BA06” device from the list. Has the pairing been successful, the transmitter’s LED will stay solid green. – In case your mobile device requests a password, please try the combination “0000“, “1111“, “8888” or “1234”.
Step 4
In case the audio transmitter and the mobile devices were paired previously, it’s no more required to start pairing again since both devices will repair automatically next time.
Additional Information
A “factory reset” of the TaoTronics transmitter is carried out by connecting a cable to the USB port, because the device is rebooted every time. In order to pair a new device, follow again steps 1 to 3 as outlined above.
The blue, green and red LEDs on the TaoTronics TT-BA06 audio transmitter have different meanings.
| LED Status | Transmitter Status |
| LEDs off |
The transmitter is turned off OR the battery is fully charged. Total battery run-time is approx 10 hours. |
| LED flashes blue and green | The transmitter is turned on. Press and hold the power button for approx 3 seconds. |
| LED solid red |
The battery is getting charged. A full battery charging cycle takes about 1 hours. The transmitter can be used while getting charged. Note that the pairing is reset when plugging in the USB cable. |
| LED stays red 3 seconds |
The transmitter is turned off. Press and hold the power button for approx 3 seconds. |
| LED flashes red and green |
The transmitter is set to the Bluetooth pairing mode. |
| LED flashes blue once every 10 seconds |
The transmitter is properly connected to a device. |
| LEDs flash blue and green simultaneously every 3 seconds |
The transmitter is set to the stand-by mode. |
| LED solid green |
The Bluetooth connection has been established. |