How can you pair the TaoTronics Audio Transmitter with a mobile device via Bluetooth? What do the LED colors mean? How to perform a reset?
CAUTION: Electrical Device. Read the safety instructions!
Ensure that the TaoTronics TT-BA01 audio transmitter battery is fully charged and connected via the 3.5 mm audio jack to the audio system. You will have to select the “AUX” oder “Line-Out” jack as a source. Do not separate the two devices for more than 3 feet while pairing.
Press and hold the power button (middle) on the unit for approx 6-7 seconds. First the blue LED flashes, then the red and blue LEDs will flash alternatively. The transmitter is now ready for pairing and can be connected with other Bluetooth enabled devices. If no Bluetooth connection will be established within 2 minutes, the transmitter turns off automatically.
Turn on the Bluetooth mode on your mobile device. It will automatically search for other Bluetooth enabled devices nearby. Choose the “TaoTronics TT-BA01” device from the list. Has the pairing been successful, the transmitter’s LED will flash red once every 10 seconds. – In case your mobile device requests a password, please try the combination “0000“, “1111“, “8888” or “1234”.
In case the audio transmitter and the mobile devices were paired previously, it’s no more required to start pairing again since both devices will repair automatically next time.
In order to perform a “factory reset”, switch on the TT-BA01 transmitter first. Press the power button 2 times. Then the transmitter must be switched off again. The transmitter is now set back and can be connected to a new device. However, the manufacturer emphasizes that the reset may have to be repeated several times.
The blue and red LEDs on the TaoTronics TT-BA01 audio transmitter have different meanings.
|LED Status||Transmitter Status|
||The battery is fully charged. Total battery run-time is approx 6-7 hours.|
|LED flashes blue
||The transmitter is turned on. Press and hold the power button for approx 3-5 seconds.|
|LED solid red
||The battery is getting charged. A full battery charging cycle takes about 2 hours. The transmitter can be used while getting charged.|
|LED flashed red 3 times
||The transmitter is turned off. Press and hold the power button for approx 3 seconds.|
|LED flashes red and blue
||The transmitter is set to the Bluetooth pairing mode.|
|LED flashes blue once every 10 seconds
||The transmitter is properly connected to a device.|
|LED flashes blue twice every 5 seconds
||The transmitter is set to the stand-by mode.|
|LED flashes red once every 10 seconds
||The Bluetooth connection has been established.|