How can you pair the Senso ActivBuds Sport Headphone with a mobile device via Bluetooth? What do the LED colors mean? How to use the buttons?
Manufacturer: Senso
|
CAUTION: Electrical Device. Read the safety instructions!
Step 1
Ensure that the Senso ActivBuds S300 headphone is turned off and the battery fully charged. Do not separate the two devices for more than 3 feet while pairing.
Step 2
Press and hold the multi function button for approx 6 seconds until the blue and red LED flashes alternatively. A voice signal will prompt “Pairing State”. The headphone is now ready for pairing and can be connected with other Bluetooth enabled devices.
Step 3
Turn on the Bluetooth mode of your mobile device. It will automatically search for other Bluetooth enabled devices nearby. Choose the “ActiveBuds S300” device from the list. Has the pairing been successful, the headphone’s LED will flash blue every 5 seconds. – In case your mobile device requests a password, please try the combination “0000” or “8888“.
Step 4
The headphone will always try to connected to the last used device (mobile phone, tablet, computer) once powered up.
If you want to connect the Senso ActivBuds S300 headphone with another device, simply turn off the Bluetooth function on the first device (for instance “disconnect”) and follow again the above steps 1 to 3. Both devices are now connected to the Senso headphone but only one of them can play music or make phone calls.
Additional Information
In order to perform a factory reset, simply press and hold the multi function button for approx 3 seconds while the headphone is getting charged. Once the blue and red LED flash three times, release the multi function button again.
The following functions can be controlled via the three different buttons.
Function | Button How To / Control |
Power On | Press and hold the multi function button for approx 2 seconds. |
Power Off | Press and hold the multi function button for approx 3 seconds. |
Play / Pause | Press the multi function button once. |
Volume Up / Down | Press the volume up (+) / down (-) button. |
Next / Previous Title | Press and hold the volume up (+) / down (-) button for approx 2 seconds. |
Pick Up Call | Press the multi function button once. |
End Call | Press the multi function button once. |
Reject Call | Press and hold the multi function button for approx 2 seconds. |
Redial last Number | Press the multi function button twice. |
Start Pairing | Press and hold the multi function button for approx 6 seconds. |
The blue and red LEDs on the headphone control unit have different meanings.
LED Status | Headphone Status |
LED off |
The headphone is turned off. |
LED flashes red |
The battery is almost empty and must be charged. |
LED solid red |
The battery is getting charged. A full battery charging cycle is about 2 hours. – If the LED is not turning solid red, the battery might not have been charged for a while. Keep charging the device approx 30 minutes. Then the LED will turn solid red. |
LED flashes blue |
The headphone is set to the Bluetooth pairing mode. |
LED solid blue |
The battery is fully charged. Total battery run-time is approx 8 hours. |
LED flashes blue every 2 seconds |
The headphone is not paired with a device. |
LED flashes blue every 5 seconds |
The headphone is paired with a device. |